Address

Author Topic: What 3d printer firmware, driver board, and computer software is everybody using  (Read 1157 times)

Ben2

  • FamiLAB Member
  • Jr. Member
  • *
  • Posts: 95
    • View Profile
I'm building a 3d Printer from scratch and wondered what firmware, driver board, and computer software for sending g-code, combos everyone is using.  I met many people who are using Marlin, Ramps 1.4 board, and Ponterface as a combo to run their g-code. 
There are so many combinations out there... what combinations are all of you using?  What are some other good combos you've heard of.  Any firmware/ driver boards/ computer software to steer clear of?
Thanks everybody,
-Ben2

PockyBum522

  • Pocky
  • Sr. Member
  • ****
  • Posts: 440
  • Oh alcohol, I still drink to your health~
    • View Profile
Marlin, Ramps, and repetier host, kissslicer, or cura, in that order. I'll let the more experienced ones chime in, but I think that about covers it.