Address

Author Topic: Should this be a public board?  (Read 1457 times)

f00bard

  • FamiLAB Member
  • Newbie
  • *
  • Posts: 0
  • Da Real MVP
    • View Profile
Should this be a public board?
« on: March 20, 2012, 01:38:10 PM »
So one hope with the forum is that we can replace the familab-discuss board while adding more specific forums for the subgroups we have (biohacking, micros, etc.).  The familab-discuss mailing list was always viewable by the public (see archives here: http://familab.org/pipermail/familab-discuss_familab.org/).  Hmm, according to past me, we should have both: http://familab.org/pipermail/familab-discuss_familab.org/2010-March/000006.html

 ???

ThantiK

  • FamiLAB Member
  • Full Member
  • *
  • Posts: 237
  • Resident 3D printer guru.
    • View Profile
Re: Should this be a public board?
« Reply #1 on: March 20, 2012, 02:45:56 PM »
Just wondering if there's a way to tie in the mailing list with the forums.  Does this software have a plugin for "Quick Reply" - that would be nice too, would cut down on page requests.

f00bard

  • FamiLAB Member
  • Newbie
  • *
  • Posts: 0
  • Da Real MVP
    • View Profile
Re: Should this be a public board?
« Reply #2 on: March 20, 2012, 03:15:08 PM »
Might be at the bottom already as an expandable box, or is in your profile settings under Look and Layout.

ThantiK

  • FamiLAB Member
  • Full Member
  • *
  • Posts: 237
  • Resident 3D printer guru.
    • View Profile
Re: Should this be a public board?
« Reply #3 on: March 20, 2012, 03:33:16 PM »
Ah, yikes this forum layout just wastes a lot of space and is kind of horribly laid out.  I have a feeling JBC will fix that though.